Garmin 520/1000 Bar Mount + Di2 Junction Holder
Garmin Edge 520/1000 + Di2 Holder
All of the Raceware 3D Printed products are designed; manufactured and hand finished in the UK.
The Raceware Garmin road bar mount is designed to hold the GPS unit central and above the top of the handlebars and in the middle of the stem. The di2 junction clips to a holder underneath the mount
The clamp is flexible enough to allow installation by opening the clamp to fit over the bars. They are made from 3D printed nylon and available in a wide range of colours and sizes. These mounts are supplied with a high quality stainless steel bolt and self adhesive rubber gripper to avoid bar slippage.
The Clamp distance is the gap in mm’s between the two bands that fit either side of the stem.