Description
Garmin Edge + Go Pro + Exposure Light Bar Mount
All of the Raceware 3D Printed products are designed; manufactured and hand finished in the UK.
The Raceware Garmin road bar mount is designed to hold the GPS unit central and above the top of the handlebars and in the middle of the stem. The Gopro camera then hangs below in front of the stem.
If you attach the supplied bracket instead of the GoPro then you can fit any of the larger Exposure lights using the original QR bar mount that is supplied with the light.
The clamp is flexible enough to allow installation by opening the clamp to fit over the bars. They are made from 3D printed nylon and available in a wide range of colours and sizes. These mounts are supplied with a high quality stainless steel bolt and self adhesive rubber gripper to avoid bar slippage.
The Clamp distance is the gap in mm’s between the two bands that fit either side of the stem.
Specifications
Interface:
Garmin Edge ¼ turn models (200/500/510/520/800/810/820)
GoPro Hero Cameras
Exposure Lights
Material:
3D Printed Nylon
Location:
Handlebars
Bar Sizes:
25.4mm, 31.8mm, 35mm
Clamp Distance:
42mm or 52mm
Colours:
Black, white, Red, Blue, Pink, Green, Orange, Yellow, Purple, Neon Yellow, Neon Orange, Neon Pink
Reviews
There are no reviews yet.